Avaya Configuring Dial Services Manual de usuario Pagina 281

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 326
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 280
114062 Rev. A A-1
Appendix A
Configuration Examples
This appendix provides examples for configuring the following applications:
Dial-on-demand using V.25bis signaling
Dial-on-demand over an ISDN network
Dial backup using Raise DTR signaling with PPP and Bay Networks Standard
over the primary line
Dial backup over an ISDN network with PPP, Bay Networks Standard, and
Frame Relay over the primary line
These examples show which parameters require changes from their default
settings for proper configuration. A sample network picture illustrates each type
of dial configuration. Each sample network picture is followed by a set of tables
that include the configuration window path to reach the parameters and the correct
parameter settings.
The ISDN examples (
page A-7 and page A-18) assume the following:
All the BRI interfaces use a National ISDN 1 (NI1) switch.
No incoming filtering on the calls.
Complete IEs are not used.
The adaption rate is 64 Kb/s.
CHAP is the PPP authentication protocol.
IP is the only LAN protocol configured.
The Ethernet segments listed on the network picture are not configured.
Only one phone number and SPID are used. (BRI lines usually have two
phone numbers and SPIDs.)
Vista de pagina 280
1 2 ... 276 277 278 279 280 281 282 283 284 285 286 ... 325 326

Comentarios a estos manuales

Sin comentarios