
Configuring Demand Circuits
114062 Rev. A
8-17
Enabling Protocols for Demand Circuits
To enable a protocol or protocols for a selected demand circuit
1.
Select Protocols > Add/Delete
at the top-left corner of the Demand
Circuits window (r
efer to Figure 8-3 on page 8-3).
Site Manager displays the Select Protocols window (Figure 8-6).
Figure 8-6. Select Protocols Window
2.
Select one or more protocols for this demand circuit, then click on OK.
For each protocol you select, the Configuration Manager displays a
protocol-specific window that prompts for required information. If you need
assistance in responding to any queries, consult the appropriate protocol
manual.
When you complete the protocol selection, Site Manager returns you to the
Demand Circuits window (refer to Figure
8-3).
Comentarios a estos manuales