Avaya Configuring Dial Services Manual de usuario Pagina 115

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 326
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 114
Creating Line Pools
114062 Rev. A
7-17
Configuring ISDN Lines
The procedure for configuring BRI at the physical layer is different from that of
PRI, so instructions for configuring B channels are divided into two sections: BRI
Interfaces and PRI Interfaces. Once you set the physical layer, you can create a
line pool. At that point, the procedure for BRI and PRI is the same.
For the D channel, the default settings support most networks, so you do not have
to edit the D channel parameters. If you would like to modify the D channel, go to
Modifying Line Pool Confi
gurations” on page 7-55.
BRI Physical Interfaces
Before you begin, remember that BRI interfaces are only available on the AN and
ASN hardware platforms.
To configure BRI lines:
1.
Begin at the Configuration Manager window (refer to Figure 7-1).
2.
Click on an ISDN connector, and Site Manager displays the Port
Application window (Figur
e 7-12).
Figure 7-12. Port Application Window for BRI
Note:
You cannot modify the D channel, until you configure at least one B
channel.
Vista de pagina 114
1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 325 326

Comentarios a estos manuales

Sin comentarios