
Configuring Dial Services
8-4
114062 Rev. A
Editing Demand Circuit Parameters
After you assign a demand circuit to a pool, Site Manager adds several buttons
(Apply, Schedule, Phone Out, Delete) to the Demand Circuits window that allow
you to edit the default parameters.
To edit the circuit parameters, you must
1.
Highlight the circuit in the Demand Circuits window (refer to
Figure 8-3).
2.
Enter new values for the parameters you want to edit using the
parameter descriptions following these procedures.
3.
Click on Apply to save the changes.
Selecting CHAP or PAP for the Demand Circuit
CHAP is the default authentication protocol. To select PAP, you must go to the
PPP Interface List window, select the special line record for dial lines, and specify
PAP in the Local Authentication Protocol parameter. For more information about
PPP and configuring authentication protocols, see
Configuring PPP Services
.
Comentarios a estos manuales