Avaya Configuring Dial Services Manual de usuario Pagina 50
- Pagina / 326
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Configuring Dial Services
1-20 114062 Rev. A
How Lines, Pools, and Circuits Work Together
For each leased circuit or demand circuit, you assign a pool ID. If the line or
bundle becomes congested, the router activates a secondary line. The secondary
circuit that runs over this line inherits the configuration and protocol
characteristics of the leased circuit.
You can assign the same bandwidth pool ID to more than one circuit. If you want
a pool of secondary lines dedicated to one specific bandwidth circuit, assign that
pool exclusively to that circuit. Remember to first configure a leased or demand
connection before configuring a bandwidth-on-demand configuration.
Activating Secondary Lines
If the secondary line from the bandwidth pool does not relieve the congestion, the
router adds up to 29 lines until the congestion is relieved. The router activates a
secondary line only for a congested line, not for a failed line.
PPP multilink detects a state of congestion based on byte counts and the
user-configurable monitor parameters. The monitor parameters let you define
congestion thresholds for the leased circuit. If data traffic exceeds a threshold, the
router tries activating a secondary line. Once the amount of traffic on the
congested line falls below the congestion threshold, the router again uses only the
leased line, demand line, or bundle. Refer to Chapter 10 for details about the
monitor parameters.
Terminating Secondary Lines
The router brings down secondary lines for any of these reasons:
• The leased line or multilink bundle fails.
• The leased circuit is no longer congested.
• The remote router terminates the connection.
• There is a physical problem with the dial-up line.
Note: Byte counts are measured prior to data compression.
- Configuring Dial 1
- Services 1
- Bay Networks Software License 3
- Contents 5
- 114062 Rev. A vii 7
- 114062 Rev. A ix 9
- 114062 Rev. A 10
- 114062 Rev. A xi 11
- 114062 Rev. A xiii 13
- 114062 Rev. A xv 15
- 114062 Rev. A xvii 17
- About This Guide 19
- Audience 20
- Before You Begin 20
- Conventions 21
- Acronyms 22
- 114062 Rev. A xxiii 23
- 114062 Rev. A xxv 25
- Bay Networks Customer Service 26
- World Wide Web 27
- Customer Service FTP 27
- Support Source CD 28
- CompuServe 28
- InfoFACTS 29
- How to Get Help 29
- Chapter 1 31
- Dial Services Overview 31
- DS0005A 32
- Dial-on-Demand Service 33
- Demand Lines and Pools 34
- 192.32.14.0 35
- 192.32.16.0 35
- Activating Demand Circuits 36
- Terminating Demand Circuits 38
- Dial Backup Service 39
- Primary Line 40
- Backup Line 40
- 1-12 114062 Rev. A 42
- Backup Lines and Pools 43
- 1-14 114062 Rev. A 44
- Activating the Backup Line 45
- 1-16 114062 Rev. A 46
- Bandwidth-on-Demand Service 47
- 1-18 114062 Rev. A 48
- Activating Secondary Lines 50
- Terminating Secondary Lines 50
- Chapter 2 53
- ISDN Overview 53
- ISDN Standards 54
- Primary Rate Interface 55
- The D Channel 55
- 2-4 114062 Rev. A 56
- Figure 2-3. LAPD Frame 56
- ISDN Interfaces 57
- Reference Points 58
- 2-8 114062 Rev. A 60
- Chapter 3 61
- Implementation Notes 61
- Types of Authentication 62
- 114062 Rev. A 3-3 63
- 3-4 114062 Rev. A 64
- Asynchronous PPP 66
- ISDN Services 68
- 114062 Rev. A 3-9 69
- 3-10 114062 Rev. A 70
- 114062 Rev. A 3-11 71
- 3-12 114062 Rev. A 72
- 114062 Rev. A 3-13 73
- Call Screening 74
- Rate Adaption 74
- Example 1 75
- Example 2 75
- 3-16 114062 Rev. A 76
- Chapter 4 77
- PPP Multilink 78
- Static Routes 79
- Traffic Filters 80
- Dial Optimized Routing 81
- 4-6 114062 Rev. A 82
- Protocol Prioritization 83
- Chapter 5 85
- Bandwidth for Backup Circuits 86
- 114062 Rev. A 5-3 87
- 5-4 114062 Rev. A 88
- 114062 Rev. A 5-5 89
- 5-6 114062 Rev. A 90
- 114062 Rev. A 5-7 91
- 5-8 114062 Rev. A 92
- Chapter 6 93
- 6-2 114062 Rev. A 94
- 6-4 114062 Rev. A 96
- 114062 Rev. A 6-5 97
- Chapter 7 99
- Caution: 100
- Pool ID Parameter 107
- Configuring Dial Services 108
- Creating Line Pools 109
- Adding Line Pools 110
- Configuring ISDN Lines 115
- PRI Physical Interfaces 117
- 7-20 114062 Rev. A 118
- 7-22 114062 Rev. A 120
- 7-24 114062 Rev. A 122
- 123
- 124
- 126
- 128
- 129
- 7-32 114062 Rev. A 130
- 131
- 7-34 114062 Rev. A 132
- 137
- 7-40 114062 Rev. A 138
- 7-42 114062 Rev. A 140
- Configuring ISDN Logical Lines 141
- 7-44 114062 Rev. A 142
- 7-46 114062 Rev. A 144
- 114062 Rev. A 7-47 145
- 7-48 114062 Rev. A 146
- 7-50 114062 Rev. A 148
- Local Phone Number Parameters 149
- 7-52 114062 Rev. A 150
- 114062 Rev. A 7-53 151
- Changing Pool IDs and Lines 153
- 114062 Rev. A 7-57 155
- 7-58 114062 Rev. A 156
- 114062 Rev. A 7-59 157
- 7-60 114062 Rev. A 158
- 114062 Rev. A 7-63 161
- 114062 Rev. A 7-65 163
- Chapter 8 165
- Configuring Demand Circuits 165
- Interface for Dialup Lines 167
- Demand Circuit Parameters 169
- Configuring Demand Circuits 171
- 184
- Deleting Demand Circuits 186
- 114062 Rev. A 8-23 187
- 8-24 114062 Rev. A 188
- 4. Click on OK to save 188
- 8-26 114062 Rev. A 190
- 8-28 114062 Rev. A 192
- 114062 Rev. A 8-29 193
- Chapter 9 197
- Configuring Backup Circuits 197
- Circuit Options Parameters 202
- Configuring Backup Circuits 205
- Interface Type Parameter 211
- 219
- 219
- 220
- 9-26 114062 Rev. A 222
- 9-28 114062 Rev. A 224
- 227
- 228
- 228
- 9-34 114062 Rev. A 230
- 114062 Rev. A 9-35 231
- (Figure 232
- Deleting Backup Circuits 234
- Chapter 10 235
- Congestion Monitor Parameters 247
- Deleting Bandwidth Circuits 255
- Chapter 11 257
- Configuring Phone Lists 257
- Configuring Phone Lists 263
- Chapter 12 273
- Configuring Caller Resolution 273
- Configuring Caller Resolution 277
- Appendix A 281
- Configuration Examples 281
- Dial-on-Demand Using PPP 282
- Table A-3. IP Parameters 284
- A-4 114062 Rev. A 284
- Phone List window 285
- A-6 114062 Rev. A 286
- Configuration of Router 1 287
- Configuration of Router 2 288
- Configuration Examples 289
- Table A-10. Demand Pools 289
- A-10 114062 Rev. A 290
- Table A-14. IP Parameters 291
- A-12 114062 Rev. A 292
- A-16 114062 Rev. A 296
- Table A-23. IP Parameters 297
- A-20 114062 Rev. A 300
- Table A-26. Backup Pools 300
- A-22 114062 Rev. A 302
- Appendix B 305
- B-4 114062 Rev. A 308
- B-6 114062 Rev. A 310
- B-8 114062 Rev. A 312
- Appendix C 313
- Ordering PRI Lines 314
- 114062 Rev. A Index-1 315
- 114062 Rev. A Index-3 317
- 114062 Rev. A Index-5 319
- 114062 Rev. A Index-7 321
- 114062 Rev. A Index-9 323
- 114062 Rev. A Index-11 325
Relacionado con productos y manuales para Manuales de software Avaya Configuring Dial Services
Manuales de software Avaya Business Communications Manager - LAN CTE Guía de configuración
(28 paginas)
(28 paginas)
Manuales de software Avaya DMC DECT Fundamentals - Communications Server 1000 Manual de usuario
(340 paginas)
(340 paginas)
Manuales de software Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario
(108 paginas)
(108 paginas)
Manuales de software Avaya Nortel Business Communications Manager 450 1.0 Unified Messaging Guía de configuración
(80 paginas)
(80 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.030 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales