Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario descargar pdf (Pagina 98)

96 Chapter 2 General CLI commands

212160-B

Figure 21 show logging command output

set logging

The set logging command configures the system settings for the system event

log. The syntax for the

set logging command is:

set logging [enable|disable] [level

critical|serious|informational] [nv-level

critical|serious|informational|none]

The set logging command is in the config command mode.

Table 38 describes the parameters and variables for the

set logging command.

Table 38 set logging command parameters and values

Parameters and variables Description

enable|disable Enables or disables the event log (default is enabled).

level critical|serious|informational Specifies the level of logging stored in DRAM.

nv-level critical|serious|informational|none Specifies the level of logging stored in NVRAM.

BPS2000#show logging informational

Type Unit Time Index Src Message

---- ---- ----------- --------- --- -------

I 1 00:00:01:52 1 Warm Start Trap

I 1 00:00:01:52 2 Enterprise Specific Trap

I 1 00:00:01:57 3 Link Up Trap

I 1 00:00:01:57 4 Link Up Trap

I 1 00:00:01:57 5 Link Up Trap

I 1 00:00:01:57 6 Link Up Trap

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 232 233

Sin comentarios

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario Pagina 98