
170 Chapter 5 VLANs and IGMP
212160-B
Figure 35 show vlan multicast membership command output
Using IGMP snooping
You can configure and display IGMP snooping parameters using the CLI. This
section covers:
• “show vlan igmp command,” next
• “vlan igmp command” on page 171
• “default vlan igmp command” on page 172
show vlan igmp command
The show vlan igmp command displays the IGMP snooping configuration. The
syntax for the
show vlan igmp command is:
show vlan igmp <1-4094>
The show vlan igmp command is in the privExec mode.
Table 101 describes the parameters and variables for the
show vlan igmp
command.
BPS2000#show multicast membership 1
Multicast Group Address Unit Port
----------------------- ---- ----
2239.255.118.187 1 19
2239.255.118.187 2 17
2239.255.118.187 2 19
2239.255.29.77 2 17
2239.255.29.77 2 19
2239.255.118.187 3 17
2239.255.118.187 3 18
2239.255.29.77 3 17
Comentarios a estos manuales