Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario Pagina 96

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 233
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 95
94 Chapter 2 General CLI commands
212160-B
default snmp trap link-status command
The default snmp trap link-status command disables the linkUp/
linkDown traps for the port. The syntax of the command is:
default snmp trap link-status [port <portlist>]
The default snmp trap link-status command is in the config-if command
mode.
Table 36 describes the parameters and variables for the default
snmp trap
link-status
command.
Table 35 no snmp trap link-status command parameters and variables
Parameters and
variables
Description
port <portlist> Specifies the port numbers to disable the linkUp/linkDown traps
on. Enter the port numbers or all.
Note: If you omit this parameter, the system uses the port number
you specified in the interface command.
Table 36 default snmp trap link-status command parameters and variables
Parameters and
variables
Description
port <portlist> Specifies the port numbers to disable the linkUp/linkDown traps
on. Enter the port numbers or all.
Note: If you omit this parameter, the system uses the port number
you specified in the interface command.
Vista de pagina 95
1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 232 233

Comentarios a estos manuales

Sin comentarios