Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario Pagina 164
- Pagina / 233
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
162 Chapter 5 VLANs and IGMP
212160-B
vlan delete command
The vlan delete command allows you to delete a VLAN. The syntax for the
vlan delete command is:
vlan delete <1-4094>
The vlan delete command is in the config command mode.
protocol-ipxEther2 Specifies an ipxEther2 protocol-based VLAN.
protocol-ApltkEther2Snap Specifies an ApltkEther2Sanp protocol-based VLAN.
protocol-decEther2 Specifies a decEther2 protocol-based VLAN.
protocol-decOtherEther2 Specifies a decOtherEther2 protocol-based VLAN.
protocol-sna802.2 Specifies an sna802.2 protocol-based VLAN.
protocol-snaEther2 Specifies an snaEther2 protocol-based VLAN.
protocol-Netbios Specifies a NetBIOS protocol-based VLAN.
protocol-xnsEther2 Specifies an xnsEther2 protocol-based VLAN.
protocol-vinesEther2 Specifies a vinesEther2 protocol-based VLAN.
protocol-ipv6Ether2 Specifies an ipv6Ether2 protocol-based VLAN.
protocol-Userdef
<4096-65534>
Specifies a user-defined protocol-based VLAN.
protocol-RarpEther2 Specifies an RarpEther2 protocol-based VLAN.
learning {IVL|SVL} Enter the type of learning you want for the VLAN:
• IVL—independent VLAN learning
• SVL—shared VLAN learning
Note: IVL is available only when you are operating in the Pure BPS 2000
stack mode.
Note: This command fails if the VLAN already exists.
Table 91 vlan create command parameters and variables (continued)
Parameters and variables Description
- Reference for the 1
- Business Policy Switch 2000 1
- Command Line Interface 1
- Release 2.0 1
- Trademarks 2
- Restricted rights legend 2
- Statement of conditions 2
- USA requirements only 3
- European requirements only 3
- Taiwan requirements 4
- Canada requirements only 4
- Contents 7
- Chapter 3 11
- Chapter 4 11
- Chapter 5 12
- Chapter 6 13
- Appendix A 14
- About this guide 21
- Before you begin 21
- Text conventions 22
- Related publications 23
- How to get help 24
- Preface 25 25
- 26 Preface 26
- Chapter 1 27
- CLI Basics 27
- Stacking compatibility 28
- Chapter 1 CLI Basics 27 29
- New features 30
- CLI command modes 31
- 30 Chapter 1 CLI Basics 32
- Port numbering 34
- IP notation 36
- Accessing the CLI 37
- 36 Chapter 1 CLI Basics 38
- Figure 2 BPS 2000 banner 38
- Setting the CLI password 40
- Getting help 41
- Basic navigation 41
- General navigation commands 42
- Keystroke navigation 43
- Parameters 47
- BPS2000#show stack-info 51
- Chapter 1 CLI Basics 51 53
- BPS2000#show stack-oper-mode 56
- Chapter 1 CLI Basics 55 57
- 56 Chapter 1 CLI Basics 58
- Chapter 2 59
- General CLI commands 59
- Setting the terminal 60
- Configuration Filename: 65
- Setting Telnet access 73
- Setting boot parameters 77
- Setting TFTP parameters 81
- Upgrading software 84
- Observing LED indications 86
- Upgrading software images 87
- Displaying interfaces 90
- Setting SNMP parameters 92
- Setting the system event log 97
- Displaying port statistics 100
- Enabling or disabling a port 102
- Naming ports 104
- Setting port speed 105
- Enabling Autopology 109
- Enabling flow control 111
- Enabling rate-limiting 113
- Security 117
- Using MAC address security 122
- Index Mac Address 124
- _____ _________________ 124
- 1 00-60-AF-00-12-30 124
- command is: 125
- Using EAPOL-based security 130
- Using RADIUS authentication 133
- 134 Chapter 3 Security 136
- 212160-B 136
- Using MLT 150
- Using port-mirroring 153
- VLANs and IGMP 157
- 156 Chapter 5 VLANs and IGMP 158
- Parameters and 159
- Description 159
- Using IGMP snooping 172
- Displaying QoS parameters 176
- IP Filter Sets 181
- Resetting 187
- Configuring COPS 188
- Configuring QoS actions 206
- Configuring QoS meters 207
- Configuring QoS shapers 208
- Gathering QoS statistics 210
- Configuring QoS policies 211
- Reordering packets 213
- Command List 215
- 214 Appendix A Command List 216
- Appendix A Command List 215 217
- 216 Appendix A Command List 218
- Appendix A Command List 217 219
- 218 Appendix A Command List 220
- Appendix A Command List 219 221
- 220 Appendix A Command List 222
- Appendix A Command List 221 223
- 222 Appendix A Command List 224
- Appendix A Command List 223 225
- 224 Appendix A Command List 226
Relacionado con productos y manuales para Los conmutadores de red Avaya Business Policy Switch 2000 Command Line Interface Release 2.0
(31 paginas)
(13 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales