Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario Pagina 71

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 233
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 70
Chapter 2 General CLI commands 69
Reference for the Business Policy Switch 2000 Command Line Interface
no ip address unit command
The no ip address unit command sets the IP address for the specified unit in
a stack to all zeros (0). The syntax for the
no ip address unit command is:
no ip address unit <1-8>
The no ip address unit command is in the config command mode.
Table 18 describes the parameters and variables for the
no ip address unit
command.
Table 17 ip address unit command parameters and variables
Parameters and
variables
Description
unit <1-8> Sets the unit you are assigning an IP address.
A.B.C.D Enter IP address in dotted decimal notation.
Note: When you change the IP address or subnet mask, you may lose
connection to Telnet and the Web.
Table 18 no ip address command parameters and variables
Parameters and
variables
Description
unit <1-8> Zeroes out the IP address for the specified unit.
Vista de pagina 70
1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 232 233

Comentarios a estos manuales

Sin comentarios