Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario descargar pdf (Pagina 93)

Chapter 2 General CLI commands 91

Reference for the Business Policy Switch 2000 Command Line Interface

snmp-server command

The snmp-server command configures various SNMP parameters. The syntax

for the

snmp-server command is:

snmp-server {{enable|disable}|authentication-trap|community

<community-string> [ro|rw] contact <text>|host <host-ip>

<community-string>|location <text>|name <text>}

The snmp-server command is in the config command mode.

Table 32 describes the parameters and variables for the

snmp-server command.

Table 32 snmp-server command parameters and variables

Parameters and variables Description

authentication-trap Enables generation of SNMP authentication failure traps.

community <community-string> Changes the read-only (ro) or read-write (rw) community strings for

SNMP v1 and SNMPv2c access. Enter a community string that

works as a password and permits access to the SNMP protocol.

ro|rw Specifies read-only or read-write access. Stations with ro access can

only retrieve MIB objects, and stations with rw access can retrieve

and modify MIB objects.

Note: If neither ro nor rw is specified, ro is assumed (default).

contact <text> Specifies the SNMP sysContact value; enter an alphanumeric string.

host <host-ip> <community-string> Configures an SNMP trap destination:

• host-ip—enter a dotted-decimal IP address of a host that will be

the trap destination

• community-string—enter a community string that works as a

password and permits access to the SNMP protocol

location <text> Specifies the SNMP sysLocation value; enter an alphanumeric

string.

name <text> Specifies the SNMP sysName value; enter an alphanumeric string.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 232 233

Sin comentarios

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario Pagina 93