
50 Chapter 1 CLI Basics
212160-B
The renumber unit command has no parameters or variables.
Managing MAC address forwarding database table
This section shows you how to view the contents of the MAC address forwarding
database table, as well as setting the age-out time for the addresses. The following
topics are covered:
• “show mac-address-table command,” next
• “mac-address-table aging-time command” on page 52
• “default mac-address-table aging-time command” on page 53
show mac-address-table command
The show mac-address-table command displays the current contents of the
MAC address forwarding database table. The syntax for the
show
mac-address-table
command is:
show mac-address-table [vid <1-4094>] [aging-time] [address
<H.H.H>]
The show mac-address-table command is in the privExec command mode.
Table 6 describes the parameters and variables for the
show
mac-address-table command.
Note: This command does not take effect until you reset the stack.
Comentarios a estos manuales