Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario descargar pdf (Pagina 104)

102 Chapter 2 General CLI commands

212160-B

Naming ports

You can name a port using the CLI. This section covers the following commands:

• “name command,” next

• “no name command” on page 102

• “default name command” on page 103

name command

The name command allows you to name ports or to change the name. The syntax

for the

name command is:

name [port <portlist>] <LINE>

The name command is in the config-if command mode.

Table 44 describes the parameters and variables for the

name command.

no name command

The no name command clears the port names; it resets the field to an empty string.

The syntax for the

no name command is:

no name [port <portlist>]

The no name command is in the config-if command mode.

Table 44 name command parameters and variables

Parameters and

variables

Description

port <portlist> Specifies the port numbers to name.

Note: If you omit this parameter, the system uses the port number

you specified in the interface command.

<LINE> Enter up to 26 alphanumeric characters.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 232 233

Sin comentarios

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario Pagina 104