
Chapter 3 Security 131
Reference for the Business Policy Switch 2000 Command Line Interface
Using RADIUS authentication
Using a the RADIUS protocol and a server, you can configure the BPS 2000 for
authentication. With the CLI system, you use the following commands:
• “show radius-server command,” next
• “radius-server command” on page 132
• “no radius-server command” on page 133
show radius-server command
The show radius-server command displays the RADIUS server
configuration. The syntax for the
show radius-server command is:
show radius-server
The show radius-server command is in the privExec command mode.
The
show radius-server command has no parameters or variables.
Figure 27 displays sample output from the
show radius-server command.
server-timeout <num> Specifies a waiting period for response from the server. Enter the number
of seconds you want to wait; range is 1-65535
max-request <num> Enter the number of times to retry sending packets to supplicant.
Table 70 eapol command for modifying parameters and variables
Parameters and variables Description
Comentarios a estos manuales