Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario Pagina 113

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 233
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 112
Chapter 2 General CLI commands 111
Reference for the Business Policy Switch 2000 Command Line Interface
Enabling rate-limiting
You can limit the percentage of multicast traffic, or broadcast traffic, or both using
the CLI. For more information on rate-limiting, refer to Using the Business Policy
Switch 2000 Software Version 2.0.
This section covers:
show rate-limit command, next
rate-limit command on page 112
no rate-limit command on page 113
default rate-limit command on page 114
show rate-limit command
The show rate-limit command displays the rate-limiting settings and
statistics. The syntax for the
show rate-limit command is:
show rate-limit
The show rate-limit command is in the privExec command mode.
The
show rate-limit command has no parameters or variables.
Figure 23 displays sample output from the
show rate-limit command.
Table 53 default flowcontrol command parameters and variables
Parameters and
variables
Description
port <portlist> Specifies the port numbers to default to auto flow control.
Note: If you omit this parameter, the system uses the port
number you specified in the interface command.
Vista de pagina 112
1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 232 233

Comentarios a estos manuales

Sin comentarios