
46 Chapter 1 CLI Basics
212160-B
• In Global Configuration (config) mode, exit moves you back to the privExec
command mode.
• In Interface Configuration (config-if) command mode,
exit moves you back
to the config mode.
The syntax for the
exit command is:
exit
The exit command has no parameters or variables.
Managing basic system information
This section shows you how to view basic system information, such as the current
software version and the stack mode; you can renumber the units within a stack.
The following topics are covered:
• “show sys-info command,” next
• “show cpu-utilization command” on page 47
• “show memory-utilization command” on page 48
• “show stack-info command” on page 49
• “renumber unit command” on page 49
Refer to Using the Business Policy Switch 2000 Software Version 2.0, for more
information on the operation of the stack mode, including unit numbering.
show sys-info command
The show sys-info command displays the current system characteristics. The
syntax for the
show sys-info command is:
show sys-info
The show sys-info command is in the privExec command mode.
The
show sys-info command has no parameters or variables.
Comentarios a estos manuales