Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario descargar pdf (Pagina 150)

148 Chapter 4 Spanning Tree, MLT, and Port-Mirroring

212160-B

Table 83 describes the parameters and variables for the no spanning-tree

command by port.

Using MLT

You configure Multi-Link Trunking (MLT) using the following commands:

• “show mlt command,” next

• “mlt command” on page 149

• “no mlt command” on page 150

show mlt command

The show mlt command displays the Multi-Link Trunking (MLT) configuration

and utilization. The syntax for the

show mlt command is:

show mlt [utilization <1-6>]

Table 83 no spanning-tree command by port parameters and variables

Parameters and

variables

Description

port <portlist> Disables spanning tree for the specified port or ports; enter port

or ports you want enabled for STP.

Note: If you omit this parameter, the system uses the port

number you specified when you issued the

interface

command.

stp <1-8> Disables the port in the specified spanning tree group; enter the

STG ID.

Note: For guidelines for configuring STGs, VLANs, and MLTs, refer to

Chapter 1 of the Using the Business Policy Switch 2000 Software Version

2.0.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 232 233

Sin comentarios

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario Pagina 150