
Chapter 3 Security 121
Reference for the Business Policy Switch 2000 Command Line Interface
Table 61 describes the parameters and variables for the show mac-security
command.
Figure 25 displays sample output from the
show mac-security command.
Figure 25 show mac-security command output
show mac-security mac-da-filter command
The show mac-security mac-da-filter command displays configuration
information for filtering MAC destination addresses (DAs). You can filter packets
from up to 10 MAC DAs. The syntax for the
show mac-security
mac-da-filter
command is:
show mac-security mac-da-filter
Table 61 show mac-security command parameters and variables
Parameters and
variables
Description
config Displays general BaySecure configuration.
mac-address-table
[address <macaddr>]
Displays contents of BaySecure table of allowed MAC
addresses:
• address—specifies a single MAC address to display;
enter the MAC address
port Displays the BaySecure status of all ports.
security-lists Displays port membership of all security lists.
BPS2000#show mac-security config
MAC Address Security: Disabled
MAC Address Security SNMP-Locked: Disabled
Partition Port on Intrusion Detected: Disabled
DA Filtering on Intrusion Detected: Disabled
Generate SNMP Trap on Intrusion: Disabled
Current Learning Mode: Disabled
Learn by Ports:
Comentarios a estos manuales