Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario descargar pdf (Pagina 211)

Chapter 6 Policy-enabled networks and QoS 209

Reference for the Business Policy Switch 2000 Command Line Interface

Configuring QoS policies

You configure QoS policies using the CLI.

qos policy command

The qos policy command creates or deletes a QoS policy. The syntax for the

qos policy command is:

qos policy <polid> {create [name <polname>]

if-group <ifgroup> filter-set-type {ip|l2}

{filter-set <setid>|filter-set-name <setname>}

{{in-profile-action <actid>|in-profile-action-name

<actname>}|

{{meter <metid>|meter-name <metname>}

{in-profile-action <actid>|in-profile-action-name <actname>}

{out-profile-action <actid>|out-profile-action-name

<actname>}}}

[shaper <shapeid>|shaper-name <shapename>]

[shaper-group <shapegroup>]

[track-statistics {enable|disable}]order <order>|

delete|enable|disable}

The qos policy command is in the config command mode.

Table 124 describes the parameters and variables for the

qos policy command.

Table 124 qos policy command parameters and variables

Parameters and variables Description

<polid> Enter an integer to specify the QoS policy; range is 1 to 65535.

create Creates the QoS policy.

name <polname> Assigns a name to the QoS policy with the designated policy ID. Enter the

name for the policy; maximum is 16 alphanumeric characters.

if-group <ifgroup> Enter the interface group name to which this policy applies.

filter-set-type {ip|l2} Enter the type of filter set associated with this policy:

• ip—specifies IP filter set

• l2—specifies Layer 2 filter set

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 232 233

Sin comentarios

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario Pagina 211