Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario descargar pdf (Pagina 94)

92 Chapter 2 General CLI commands

212160-B

no snmp-server command

The no snmp-server command disables SNMP or clears the configuration. If

you omit the parameters, this command disables SNMP access. The syntax for the

no snmp-server command is:

no snmp-server [authentication-trap|community [ro|rw]

contact|host [<host-ip> <community-string>]|location |name]

The no snmp-server command is in the config command mode.

Table 33 describes the parameters and variables for the

snmp-server command.

Table 33 no snmp-server command parameters and variables

Parameters and variables Description

enable|disable With no parameters, disables SNMP access.

authentication-trap Disables authentication failure traps.

community Disables the community string.

ro|rw Disables either read-only or read-write access.

contact <text> Clears the SNMP sysContact value.

host <host-ip> <community-string> Removes an SNMP trap destination or all destinations.

location Clears the SNMP sysLocation value.

name Clears the SNMP sysName value

Note: Disabling SNMP access will also lock you out of the DM

management system.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 232 233

Sin comentarios

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario Pagina 94