
Chapter 6 Policy-enabled networks and QoS 211
Reference for the Business Policy Switch 2000 Command Line Interface
Reordering packets
Support for certain per-hop behaviors (PHBs) requires packets within a flow be
reordered upon transmission. Using the CLI, you can assign packets to specified
egress queues.
qosagent packet-reordering command
The qosagent packet-reordering command allows you to reorder packets
for transmission. The syntax for the
qosagent packet-reordering command
is:
qosagent packet-reordering {enable|disable}
The qosagent packet-reordering command is in the config command
mode.
Table 125 describes the parameters and variables for the
qosagent
packet-reordering
command.
Table 125 qosagent packet-reordering command parameters and variables
Parameters and
variables
Description
enable|disable Set packet-reordering to:
• Enable—allows full flexibility in terms of the egress queue to
which a packet is assigned.
• Disable—the system verifies that in-profile and out-of-profile
actions associated with a flow will not cause packets from the
same flow to be assigned to different egress queues.
Comentarios a estos manuales