Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario descargar pdf (Pagina 70)

68 Chapter 2 General CLI commands

212160-B

Figure 14 show ip command output

Assigning and clearing IP addresses for specific units

Beginning with software version 2.0, you can assign IP addresses for specific

units within a stack. This section covers these topics:

• “ip address unit command,” next

• “no ip address unit command” on page 69

• “default ip address unit command” on page 70

ip address unit command

The ip address unit command sets the IP address and subnet mask for a

specific unit in the stack. The syntax for the

ip address unit command is:

ip address unit <1-8> A.B.C.D]

The ip address unit command is in the config command mode.

Table 17 describes the parameters and variables for the

ip address unit

command.

BPS2000>show ip

BootP Mode: BootP Disabled

Configured In Use Last BootP

--------------- --------------- ---------------

Stack IP Address: 10.10.40.29 10.10.40.29 0.0.0.0

Switch IP Address: 0.0.0.0 0.0.0.0

Subnet Mask: 255.255.255.0 255.255.255.0 0.0.0.0

Default Gateway: 10.10.40.1 10.10.40.1 0.0.0.0

BPS2000>

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 232 233

Sin comentarios

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario Pagina 70