
Chapter 2 General CLI commands 95
Reference for the Business Policy Switch 2000 Command Line Interface
Setting the system event log
You can set the system event log to log different levels of events. This section
covers:
• “show logging,” next
• “set logging” on page 96
• “no set logging” on page 97
• “default set logging” on page 97
• “clear logging command” on page 97
show logging
The show logging command displays the current contents of the system event
log. The syntax for the
show logging command is:
show logging [critical] [serious] [informational]
The show logging command is in the privExec command mode.
Table 37 describes the parameters and variables for the
show logging
command.
Figure 21 shows the output of the
show logging informational command.
Table 37 show logging command parameters and variables
Parameters and
variables
Description
critical Displays critical log messages.
serious Displays serious log messages.
informational Displays informational log messages.
Comentarios a estos manuales