Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Manual de usuario Pagina 84
- Pagina / 233
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
82 Chapter 2 General CLI commands
212160-B
Upgrading software
You can download the BPS 2000 software image that is located in non-volatile
flash memory. To download the BPS 2000 software image, a properly configured
Trivial File Transfer Protocol (TFTP) server must be present in your network, and
the policy switch must have an IP address. To learn how to configure the switch or
stack IP address, refer to “Assigning and clearing IP addresses” on page 63.
This section covers the following topics:
• “download command,” next
• “Observing LED indications” on page 84
• “Upgrading software images” on page 85
download command
The download command upgrades the software for the BPS 2000. You can
upgrade both the software image and the diagnostics image. If you upgrade to a
stack configuration, the entire stack will be upgraded, and the new image is loaded
onto every unit of the stack.
The syntax for the
download command is:
download [address <ip>] {image <image-name> [bs450-image
<image-name>]|diag <filename>}
The download command is in the privExec command mode.
Caution: Do not interrupt power to the device during the software
download process. A power interruption can corrupt the firmware image.
Note: The system resets after downloading a new image.
- Reference for the 1
- Business Policy Switch 2000 1
- Command Line Interface 1
- Release 2.0 1
- Trademarks 2
- Restricted rights legend 2
- Statement of conditions 2
- USA requirements only 3
- European requirements only 3
- Taiwan requirements 4
- Canada requirements only 4
- Contents 7
- Chapter 3 11
- Chapter 4 11
- Chapter 5 12
- Chapter 6 13
- Appendix A 14
- About this guide 21
- Before you begin 21
- Text conventions 22
- Related publications 23
- How to get help 24
- Preface 25 25
- 26 Preface 26
- Chapter 1 27
- CLI Basics 27
- Stacking compatibility 28
- Chapter 1 CLI Basics 27 29
- New features 30
- CLI command modes 31
- 30 Chapter 1 CLI Basics 32
- Port numbering 34
- IP notation 36
- Accessing the CLI 37
- 36 Chapter 1 CLI Basics 38
- Figure 2 BPS 2000 banner 38
- Setting the CLI password 40
- Getting help 41
- Basic navigation 41
- General navigation commands 42
- Keystroke navigation 43
- Parameters 47
- BPS2000#show stack-info 51
- Chapter 1 CLI Basics 51 53
- BPS2000#show stack-oper-mode 56
- Chapter 1 CLI Basics 55 57
- 56 Chapter 1 CLI Basics 58
- Chapter 2 59
- General CLI commands 59
- Setting the terminal 60
- Configuration Filename: 65
- Setting Telnet access 73
- Setting boot parameters 77
- Setting TFTP parameters 81
- Upgrading software 84
- Observing LED indications 86
- Upgrading software images 87
- Displaying interfaces 90
- Setting SNMP parameters 92
- Setting the system event log 97
- Displaying port statistics 100
- Enabling or disabling a port 102
- Naming ports 104
- Setting port speed 105
- Enabling Autopology 109
- Enabling flow control 111
- Enabling rate-limiting 113
- Security 117
- Using MAC address security 122
- Index Mac Address 124
- _____ _________________ 124
- 1 00-60-AF-00-12-30 124
- command is: 125
- Using EAPOL-based security 130
- Using RADIUS authentication 133
- 134 Chapter 3 Security 136
- 212160-B 136
- Using MLT 150
- Using port-mirroring 153
- VLANs and IGMP 157
- 156 Chapter 5 VLANs and IGMP 158
- Parameters and 159
- Description 159
- Using IGMP snooping 172
- Displaying QoS parameters 176
- IP Filter Sets 181
- Resetting 187
- Configuring COPS 188
- Configuring QoS actions 206
- Configuring QoS meters 207
- Configuring QoS shapers 208
- Gathering QoS statistics 210
- Configuring QoS policies 211
- Reordering packets 213
- Command List 215
- 214 Appendix A Command List 216
- Appendix A Command List 215 217
- 216 Appendix A Command List 218
- Appendix A Command List 217 219
- 218 Appendix A Command List 220
- Appendix A Command List 219 221
- 220 Appendix A Command List 222
- Appendix A Command List 221 223
- 222 Appendix A Command List 224
- Appendix A Command List 223 225
- 224 Appendix A Command List 226
Relacionado con productos y manuales para Los conmutadores de red Avaya Business Policy Switch 2000 Command Line Interface Release 2.0
(31 paginas)
(13 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.237 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales