
54 Avaya Video Conferencing Manager Deployment Guide
By default, trap forwarding is enabled. To disable trap forwarding, clear the Enable Avaya
Video Conferencing Manager Northbound Settings check box on the Northbound
Settings page in Avaya Video Conferencing Manager Administrator and refresh your
browser. If you disable trap forwarding, the Northbound tab on the Device details page
does not appear. For more information about using Avaya Video Conferencing Manager
Administrator, refer to “Using Avaya Video Conferencing Manager Administrator”
on page 88.
Note: If you configure global trap destinations in Avaya Video Conferencing Manager
Administrator and trap destinations on the Device details page for a single device,
Avaya Video Conferencing Manager forwards traps for that device to all trap
destinations specified in both Avaya Video Conferencing Manager Administrator
and on the Device details page.
Follow these steps to specify a trap destination to forward traps from a single device:
1. Access the Devices page.
2. In the Display list, click Managed: all.
3. Right-click the managed device from which to forward alarms and then click View
details. The Device details page appears.
4. Click the Northbound tab.
Note: If trap forwarding is disabled in Avaya Video Conferencing Manager
Administrator, the Northbound settings on the Device details page are not available.
5. Click the Add button. The Add new destination dialog box appears.
6. Enter the following information about the SNMP trap destination:
- IP address
- port number that the remote SNMP manager is listening on for traps
- username (not to exceed 40 characters)
- password (not to exceed 40 characters)
7. Click Save. The entry appears in the table above the Add button.
Note: To edit or delete an SNMP trap destination, click the Modify this entry
icon or Remove this entry icon in the Actions column for the entry you wish to
modify or delete.
Comentarios a estos manuales