
Configuring IP Services
3-24 114065 Rev. A
Configuring an SMDS Address
By default, if the interface is connected to an SMDS network, IP uses the
SMDS-configured addresses.
You can use Site Manager to supply
• A complete SMDS E.164 address specified by the SMDS subscription
agreement that you have with your SMDS provider
• An address-resolution multicast address for this IP interface in an SMDS
network
Configuring a WAN Address for a Frame Relay Network
If the interface is connected to a Frame Relay Network, you can use Site Manager
to configure
• A broadcast address. If you enter a value for this parameter, the Frame Relay
switch, rather than the router, will broadcast the message.
• A multicast address for this IP interface that will send messages to all OSPF
routers in a Frame Relay network. If you enter a value for this parameter, the
Frame Relay switch, rather than the router, will send the message to all OSPF
routers.
• A multicast address for this IP interface that will send messages to all OSPF
designated routers in a Frame Relay network. If you enter a value for this
parameter, the Frame Relay switch, rather than the router, will send the
message to all OSPF designated routers.
Site Manager: SMDS Group Address parameter: page A-31
Site Manager: SMDS Arp Req Address parameter: page A-32
Site Manager: WAN Broadcast parameter: page A-32
Site Manager: WAN Multicast #1 parameter: page A-33
Site Manager: WAN Multicast #2 parameter: page A-33
Comentarios a estos manuales