Avaya Configuring IP Services Manual de usuario Pagina 62

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 415
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 61
Configuring IP Services
2-16 114065 Rev. A
Adding OSPF and BGP to the Circuitless Interface
Once you have created a circuitless IP interface on the router, you can add OSPF
and BGP to the interface. Begin at the Configuration Manager window and
proceed as follows:
1. Select Protocols > IP > Circuitless IP > Change Protocols.
A Select Protocols window opens, listing the protocols you can add to the
circuitless interface.
2. Select a protocol and click on OK.
The router adds the protocol to the circuitless IP interface.
Selecting Slots to Support the Circuitless Interface
By default, all slots support the IP circuitless interface.
You can use Site Manager to specify the slots that can support the circuitless
interface.
Configuring an Unnumbered IP Interface
IP allows you to configure an interface on a point-to-point connection without
using an IP address. Such an interface is called an unnumbered interface.
Point-to-point connections using unnumbered interfaces can be configured to
advertise RIP (see Note), OSPF, IBGP, DVMRP, and static routes.
The ability to establish a point-to-point link using an unnumbered IP interface
helps alleviate two of the major problems caused by the continued rapid growth of
the Internet: exhaustion of Class B network addresses and exhaustion of the 32-bit
IP address space.
The network administrator associates each unnumbered interface with the IP
address of any numbered interface on the router, including the circuitless
interface. The router can support multiple unnumbered interfaces. Multiple
unnumbered interfaces can be associated with the same IP address.
Site Manager: Slot Mask parameter: page A-34
Vista de pagina 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 414 415

Comentarios a estos manuales

Sin comentarios