Avaya Configuring IP Services Manual de usuario Pagina 55

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 415
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 54
Starting IP Services
114065 Rev. A 2-9
Starting BGP
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as interface to an attached network. For information and
instructions, see Configuring Line Services.
The Select Protocols window opens.
1. Select IP and BGP from the Select Protocols window and click on OK.
Site Manager displays the IP configuration window.
2. Edit the IP Configuration Window as described in
“Starting IP” on page 2-3.
3. Click on OK.
The BGP Configuration window opens.
4. Supply the following information:
BGP identifier. There is no default for this ID. Use Site Manager to
supply the IP address of one of the router’s interfaces.
Local autonomous system number. There is no default for this parameter.
Use Site Manager to supply the appropriate AS number.
5. Click on OK.
The BGP Peer window opens.
Site Manager: Identifier parameter: page A-1
Site Manager: Local AS parameter: page A-1
Vista de pagina 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 414 415

Comentarios a estos manuales

Sin comentarios