
Starting IP Services
114065 Rev. A 2-13
Customizing EGP
The instructions in this chapter show you how to start EGP using all default values
and settings.
For information on modifying EGP defaults, see Chapter 7.
Starting NetBIOS over IP
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as interface to an attached network. For information and
instructions, see Configuring Line Services.
The Select Protocols window opens.
1. Select IP and NetBIOS from the Select Protocols window and click on
OK.
Site Manager displays the IP configuration window.
2. Edit the IP Configuration Window as described in “Starting IP” on page
2-3.
3. Click on OK.
Adding NetBIOS to an IP Interface
To add NetBIOS to an IP interface, begin at the Configuration Manager window
and proceed as follows:
1. Click on the connector to which you want to add NetBIOS services.
2. Click on Edit Circuit.
3. Select Protocols > Add or Delete.
The Select Protocols window opens.
4. Click on NetBIOS to select it.
5. Click on OK to exit the window.
6. Select File > Exit to exit the Circuit Definition window and return to the
Configuration Manager window.
Comentarios a estos manuales