
Configuring IP Services
A-82 114065 Rev. A
Parameter: Poll Interval
Path: Configuration Manager > Protocols > IP > OSPF > Interfaces
Default: 120 seconds
Options: 1 to 2147483647 seconds
Function: Indicates the largest number of seconds allowed between hello packets sent to
an inactive nonbroadcast multiaccess neighbor.
Instructions: Either accept the default value of 120 seconds or set this parameter to some
slightly higher number for slower-speed serial lines.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.3.5.1.13
Parameter: Metric Cost
Path: Configuration Manager > Protocols > IP > OSPF > Interfaces
Default: 1
Options: 1 to 65535
Function: Indicates the cost of using this type of service on this interface. We suggest
the following values for this parameter: for > = 100 Mb/s, 1; for
Ethernet/802.3, 10; for E1, 48/ for T1, 65; for 64 Kb/s, 1562; for 56 Kb/s,
1785, for 19.2 Kb/s, 5208; for 9.6 Kb/s, 10416. This parameter allows you to
configure preferred paths. If you do want to configure a preferred path, allow
that path to retain the default value of 1 or assign it a relatively low metric
cost. Then, assign the less preferred paths a higher metric cost value.
Instructions: Either accept the default value, 1, or enter a larger number for a slower path
or a backup route.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.3.5.1.16
Comentarios a estos manuales