Avaya Configuring IP Services Manual de usuario Pagina 53

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 415
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 52
Starting IP Services
114065 Rev. A 2-7
Starting OSPF
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as interface to an attached network. For information and
instructions, see Configuring Line Services.
The Select Protocols window opens.
1. Select IP and OSPF from the Select Protocols window and click on OK.
Site Manager displays the IP Configuration window.
2. Edit the parameters on the IP Configuration window as described in
“Starting IP” on page 2-3.
Site Manager displays the Initial OSPF Global Configuration window.
This window contains a subset of the parameters that you can set to configure
the OSPF soloist.
3. When you are finished with the Initial Global Configuration window,
click on OK.
An interface-specific OSPF Area Configuration window opens.
4. Enter the ID of the area to which this interface belongs.
By default, OSPF assumes that the interface is connected to a network in the
backbone (area 0.0.0.0). Use Site Manager to specify an area ID.
5. Click on OK.
The Network Type window opens.
6. Specify the type of network to which this interface is connected.
By default, OSPF assumes that the interface is connected to a broadcast
network. Use Site Manager to specify the network type.
7. Click on OK.
Site Manager: Area ID parameter: page A-78
Site Manager: Type parameter: page A-79
Vista de pagina 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 414 415

Comentarios a estos manuales

Sin comentarios