Avaya Configuring IP Services Manual de usuario Pagina 145

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 415
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 144
Customizing OSPF Services
114065 Rev. A 5-15
Specifying the Network Type
By default, OSPF assumes that the interface is attached to a broadcast
network.You can use Site Manager to specify one of the following network types:
A broadcast network supports multiple routers and can address a single physical
message to all attached routers. Examples of such a network are Ethernet, FDDI,
and Token Ring.
A nonbroadcast multiaccess (NBMA) network supports multiple routers and
cannot address a single physical message to all routers. Examples of such a
network are Frame Relay and X.25.
A point-to-point network joins a single pair of OSPF routers. An example of such
a network would be a network of synchronous lines.
Broadcast Default. Select Broadcast if this network is a broadcast
LAN, such as Ethernet.
NBMA Select nonbroadcast multiaccess if the network is a
nonbroadcast network, such as X.25.
Point-to-point Select Point-to-point for a synchronous, point-to-point
interface.
Point-to-multipoint (STD) Select Point-to-multipoint (STD) if the network is a
point-to-multipoint network.
Point-to-multipoint Select Point-to-multipoint if you want to use the Bay
Networks proprietary solution for Frame Relay
point-to-multipoint networks.
Note: If you set this parameter to NBMA, you need to configure neighbors
manually.
Site Manager: Type parameter: page A-79
Vista de pagina 144
1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 414 415

Comentarios a estos manuales

Sin comentarios