Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario descargar pdf (Pagina 26)

Configuring SNMP, BootP, DHCP, and RARP Services

1-8

117362-C Rev 00

Starting BootP/DHCP Relay

You must use Site Manager to start BootP/DHCP relay. The BCC is not supported.

You can easily start BootP/DHCP relay using default values for all parameters. If

you decide to change some or all of the default values, refer to the instructions in

Chapter 5.

Before you begin, you must verify that you have configured IP on an interface, as

described in “Configuring IP for Global Protocols

” on page 1-2. You can,

however, enable IP, BootP, and BootP/DHCP on the router simultaneously.

If you want to add BootP and BootP/DHCP relay to a circuit on which you have

already configured IP, see Configuring and Managing Routers with Site Manager

for information about adding a protocol.

Enabling BootP/DHCP on an Interface

When you select either a link- or net-module connector, or when you finish

configuring a WAN circuit, the Select Protocols window opens.

To enable BootP/DHCP relay on an interface, complete the following tasks:

Note:

The Select Protocols window displays only those protocols that the

circuit type supports.

Site Manager Procedure

You do this For instructions, see

1. Enable BootP on the interface. “Enabling BootP on an Interface

” on page

1-6

2. Access the BootP Relay Agent Interface

Table window.

“Customizing BootP Relay Agent

Parameters” on page 4-2.

3. Set the

Pass Through Mode

parameter to

DHCP, or to BootP and DHCP. This action

allows you to select either DHCP, or BootP

and DHCP, for the

Pass Through Mode

parameter in other windows.

“Specifying the Relay Mode for Packet

Forwarding” on page 4-4.

(continued)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 175 176

Sin comentarios

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario Pagina 26