Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario descargar pdf (Pagina 107)

Customizing BootP

117362-C Rev 00

4-11

Configuring an AN to Use EZ Install over a Frame Relay PVC

If you intend to configure an AN router to use EZ Install

™

over a frame relay PVC

in group access mode, you must create a BootP client interface table. You do not

need to create this table if you configured the frame relay PVC to operate in direct

access mode.

The BootP client interface table allows you to specify and pair the IP address of a

remote AN router with the DLCI of its frame relay group access PVC.

The upstream router is a booting router’s next-hop router. By default, the booting

router’s synchronous interfaces automatically try to get IP addresses from the

upstream router. This is the EZ Install process.

If a router using EZ Install gets its address from the upstream router, and the

upstream router’s interface to that router is a frame relay group access PVC, you

must connect to the upstream router and create a BootP client interface table (in

addition to a BootP relay agent forwarding table).

For information about configuring an AN to use EZ Install, see Installing and

Operating BayStack AN and ANH Systems. For information about DLCIs and

frame relay, see Configuring Frame Relay Services.

Creating a BootP Client Interface Table

You create a BootP client interface table by specifying the client IP address and

the frame relay PVC DLCI number.

Specifying the Client IP Address

You must specify the IP address of the remote AN router that will boot using

EZ Install over a frame relay group access PVC connection to the router.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 175 176

Sin comentarios

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario Pagina 107