
Customizing the DHCP Server
117362-C Rev 00
6-3
Configuring the NetID Server Manager IP Address
You must configure the IP address of the NetID Server Manager to allow it to
communicate with the target DHCP server. To configure the IP address of the
NetID Server Manager, complete the complete the tasks in the following table:
Specifying the DHCP Server TCP Port Number
You must specify a remote TCP port number on the DHCP server to allow the
DHCP server to communicate with the NetID Server Manager using TCP. This
number must match the port number that you specify on the NetID Server
Manager.
You specify the TCP port number on the NetID Server Manager when you install
the NetID Server Manager software application. The default TCP port number is
24736. For information about specifying a remote port number for the NetID
Server Manager, see the NetID Server Products Guide.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols.
The Protocols menu opens.
2. Choose
Global Protocols
. The Global Protocols menu opens.
3. Choose
DHCP
. The DHCP menu opens.
4. Choose
Global.
The DHCP Global Parameters window
opens.
5. Set the
Server Manager IP Address
parameter. Click on Help or see the
parameter description on page A-24.
6. Click on
OK
. Site Manager saves your changes and
exits the window.
Comentarios a estos manuales