
Configuring SNMP, BootP, DHCP, and RARP Services
1-2
117362-C Rev 00
Starting Configuration Tools
Before configuring SNMP, BootP, DHCP, and RARP services, refer to the
following user guides for instructions on how to start and use the Bay Networks
configuration tool of your choice.
These guides also describe generically how to create or modify a device
configuration.
Configuring IP for Global Protocols
SNMP, BootP, DHCP, and RARP services all use the Internet Protocol (IP) for
message transport. Before you configure SNMP, BootP, DHCP, and RARP
services using the BCC or Site Manager, you must first start IP on the router.
Using Site Manager
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as an interface to an attached network. For information
and instructions, see Configuring WAN Line Services and Configuring Ethernet,
FDDI, and Token Ring Services.
Configuration Tool User Guide
Bay Command Console (BCC)
Using the Bay Command Console
(AN/BN Routers)
Site Manager
Configuring and Managing Routers
with Site Manager
Comentarios a estos manuales