
Configuring SNMP, BootP, DHCP, and RARP Services
A-18
117362-C Rev 00
BootP Address Parameters
Use the following guidelines to configure BootP and DHCP parameters in the
BOOTP Addresses window.
Parameter: DHCP Server Enable
Path: Configuration Manager > Protocols > IP > BOOTP > Relay Agent Interface
Table
Default: Disable
|
Enable
Options: Disable
Function: Specifies whether the DHCP server is enabled or disabled on this network
interface
Instructions: Select Enable to enable the DHCP server on the network interface. Select
Disable to disable the DHCP server on the network interface.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.3.1.1.21
Parameter: Input IP Address
Path: Configuration Manager > Protocols > IP > BOOTP > Relay Agent Interface
Table >
Forward I/F > Add
Default: None
Options: Any valid IP address
Function: Specifies the IP interface that receives BOOTREQUEST packets from clients.
Instructions: Enter the IP address of a numbered network interface that you want to receive
BOOTREQUEST or DHCP packets from clients, then configure this IP address
on the router, if you have not already done so.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.3.2.1.3
Comentarios a estos manuales