
117362-C Rev 00
i
Preface
This guide describes Simple Network Management Protocol (SNMP), Bootstrap
Protocol (BootP), BootP/Dynamic Host Configuration Protocol (DHCP) Relay,
DHCP server, and Reverse Address Resolution Protocol (RARP) services and
what you need to do to start and customize them on a Bay Networks
®
router.
You can use the Bay Command Console (BCC
™
) or Site Manager to configure
SNMP services on a router on a router; you must use Site Manager to configure
BootP, DHCP relay, DHCP server, and RARP services. In this guide, you will find
instructions for using both the BCC and Site Manager.
Before You Begin
Before using this guide, you must complete the following procedures. For a new
router:
• Install the router (see the installation guide that came with your router).
• Connect the router to the network and create a pilot configuration file (see
Quick-Starting Routers, Configuring BayStack Remote Access, or Connecting
ASN Routers to a Network).
Make sure that you are running the latest version of Bay Networks BayRS
™
and
Site Manager software. For information about upgrading BayRS and Site
Manager, see the upgrading guide for your version of BayRS.
Comentarios a estos manuales