
Configuring SNMP, BootP, DHCP, and RARP Services
7-2
117362-C Rev 00
Customizing RARP Parameters
After you have enabled RARP services on your router (see Chapter 1), you can
customize the router software for your specific requirements. Use the remaining
sections in this chapter as a guide.
Disabling and Reenabling RARP Interfaces
You can disable or reenable individual RARP interfaces by selecting them from a
list of interfaces in the RARP Interface Table.
To disable and reenable RARP interfaces, complete the tasks in the following
table.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
Reverse ARP
. The Reverse ARP menu opens.
4. Choose
Interface Table
. The RARP Interface Table window opens.
5. Set the
Enable/Disable
parameter. Click
on
Help
or see the parameter description
on page A-28.
6. Click on
Apply
.
7. Click on
Done
. You return to the Configuration Manager
window.
Comentarios a estos manuales