Avaya Configuring Bridging Services Manual de usuario Pagina 97

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 210
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 96
Using Source Routing Bridge Services
114060 Rev. A 2-37
Parameter: IP Encapsulation
Default: Disable
Options: Enable
| Disable
Function: Enables IP encapsulation for those packets destined for an IP network.
Instructions: Enable this parameter if the bridge borders an IP network cloud and you
want to source-route frames across this IP network. If you enable this
parameter, you must also configure the Conn. IP NTWK Ring number
parameter for IP encapsulation to occur.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.1.2.1.7
Parameter: Conn. IP NTWK Ring number
Default: 0x0
Range: 0x1 to 0xffe
Function: Identifies the ring ID of the IP network to which this bridge connects.
Instructions: Assign the same value to all Bay Networks source routing bridges that
border the IP network cloud. Make sure this value is unique among any
other ring IDs, group LAN IDs, or internal LAN IDs in the network.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.1.2.1.8
Note: Refer to “Configuring IP Encapsulation Support” earlier in this chapter
for details on IP encapsulation.
Note: You cannot modify the Conn. IP NTWK Ring number parameter unless
you first enable IP encapsulation. Refer to “Confi
guring IP Encapsulation
Support” earlier in this chapter for details on IP encapsulation.
Vista de pagina 96
1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 209 210

Comentarios a estos manuales

Sin comentarios