
Configuring Bridging Services
5-6 114060 Rev. A
Editing NML Parameters
Once you configure a circuit to support NML, you can use the Configuration
Manager to edit the NML parameters. This section describes how to edit these
parameters.
For each NML parameter, this section provides information about default settings,
valid parameter options, the parameter function, instructions for setting the
parameter, and the Management Information Base (MIB) object ID.
The Technician Interface lets you modify parameters by issuing
set and commit
commands that specify the MIB object ID. This process is equivalent to
modifying parameters using Site Manager. For more information about using the
Technician Interface to access the MIB, refer to Using Technician Interface
Software.
You access all NML parameters from the Configuration Manager window
(Figure
5-3). Refer to Configuring Routers for details on accessing this window.
Note: The instructions in this section assume that you already configured
NML on the router. If you did not, refer to Configuring Routers for details.
Caution: The Technician Interface does not verify that the value you enter for
a parameter is valid. Entering an invalid value can corrupt your configuration.
Comentarios a estos manuales