Avaya Configuring Bridging Services Manual de usuario Pagina 57

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 210
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 56
Using Transparent Bridge Services
114060 Rev. A 1-31
Spanning Tree Interface Parameter Descriptions
Use these parameter descriptions as a guide when you configure the parameters on
the Spanning Tree Interfaces window (refer to Figure
1-18).
Parameter: Enable
Default: If you added spanning tree using either the Quick-Start procedure or the
configuring-circuits procedure, this parameter defaults to Enable. If you
previously used this parameter to disable spanning tree on this circuit, the
parameter defaults to Disable.
Options: Enable
| Disable
Function: Toggles spanning tree on and off for this circuit only.
Instructions: This parameter does not allow you to add spanning tree to this circuit. To
add the spanning tree to this circuit, you must use the Configuration
Manager. (Refer to Configuring Routers for details.)
Instructions: Set this parameter to Enable or Disable.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.2.2.1.2
Parameter: Priority
Default: 128
Range: 0 to 255
Function: Assigns a priority to a bridge port. This interface priority value and the
bridge ID (bridge priority + bridge MAC address) determine whether this
port becomes the designated port when the spanning tree algorithm
converges. The lower the priority value, the higher the priority, and the
more likely it is that this port will be the designated port.
Instructions: Either accept the default value or enter a new value.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.2.2.1.4
Vista de pagina 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 209 210

Comentarios a estos manuales

Sin comentarios