Avaya Configuring Bridging Services Manual de usuario Pagina 101

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 210
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 100
Using Source Routing Bridge Services
114060 Rev. A 2-41
Parameter: Source Routing Ring Number
Default: 0x0
Range: 0x001 to 0xfff
Function: Identifies the ring number (ring ID) of this source routing circuit.
Instructions: Assign a ring number (ring ID) to this source routing circuit that is unique
among any other ring IDs, group LAN IDs, or internal LAN IDs in the
network.
You cannot use the value 0x0 that appears initially in the parameter box.
You must specify a value for this parameter that is within the given range.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.1.2.2.1.6
Parameter: Outbound STEs
Default: Accept
Options: Accept
| Block
Function: When set to Block, the bridge drops outbound STEs on this circuit. Use
this parameter to configure a static spanning tree for spanning tree
explorer packets. This parameter has no effect if you configure this
interface with the Source Routing Spanning Tree protocol.
Instructions: Set to Block only if you do not want the bridge to forward STEs on this
circuit.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.1.2.2.1.7
Note: Series 7 router software does not support dynamic source route
spanning tree. You must statically configure which ports should accept or
block STE frames. Series 8 router software does support dynamic source route
spanning tree.
Vista de pagina 100
1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 209 210

Comentarios a estos manuales

Sin comentarios