
Using Native Mode LAN Services
114060 Rev. A 5-5
Enabling NML Services
Complete the following steps to enable NML on an interface:
1. Select Native Mode LAN from the Select Protocols window.
The Select Protocol window appears after you either select a link or net
module connector, or finish configuring a WAN circuit. Note that when you
select Native Mode LAN from the menu, Configuration Manager
automatically selects the Bridge protocol.
2. Click on OK.
The Configuration Manager displays a window with the message
Do you want to edit the NML interface details?
3. Click on OK.
The Configuration Manager displays the Edit NML Interface window
(Figure
5-2).
Figure 5-2. Edit NML Interface Window
4.
For instructions on editing NML parameters and assigning an access list
to a port, refer to “Editing NML Interface P
arameters” and “Assigning
an Access List to a Port” later in this chapter.
Comentarios a estos manuales