
Using the Technician Interface to Configure and Run Packet Capture
117379-A Rev. A B-39
wfPktCaptureRxFltr2Offset = 25
wfPktCaptureRxFltr2Ref = 26
wfPktCaptureRxFltr2Size = 27
wfPktCaptureRxFltr2Match = 28
wfPktCaptureRxFltr2Group = 29
wfPktCaptureTxFltr2Type = 30
wfPktCaptureTxFltr2Offset = 31
wfPktCaptureTxFltr2Ref = 32
wfPktCaptureTxFltr2Size = 33
wfPktCaptureTxFltr2Match = 34
wfPktCaptureTxFltr2Group = 35
Packet Capture Parameter Descriptions
The following sections describe each parameter, its equivalent number, and its
valid values:
• “Basic P
arameters”
• “T
rigger Parameters”
• “F
ilter Parameters”
If you configure an invalid value for an attribute, an error message appears in the
log.
Note: Packet Capture reads attribute values only when it starts. To make
Packet Capture respond to a change to an attribute value, stop and then restart
it.
Comentarios a estos manuales