Avaya Troubleshooting Routers Guía para resolver problemas Pagina 104

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 266
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 103
Troubleshooting Routers
5-26 117379-A Rev. A
Troubleshooting the Internal Clock Settings (Lab Environments Only)
If you are using crossover cables to connect to two back-to-back routers in a lab
environment, make sure all interfaces on a given slot have consistent clock source
and speed settings. A message such as the following appears if two interfaces on a
slot have inconsistent clock settings:
Warning Sync Code: 40 “Connector COM2: clock speed does not match
other ports.”
Check the clock source and speed settings as follows:
1. Enter the following command to display the clock source setting for each
slot and connector in the router:
get wfSyncEntry.13.*
The display shows the settings for all synchronous ports on all slots in the
following format:
wfSyncEntry.wfSyncClkSource.
<slot_no.>
.
<connector_no.>
=
<setting>
The setting is 1 for internal clocking or 2 for external clocking.
2. If any of the clock source settings are 1 (for internal clocking), enter the
following command to check the clock speed:
get wfSyncEntry.14.*
The console displays the transmission and reception clock speed for each slot
and connector on the router. All ports configured for internal clocking in a slot
use the clock speed of the port most recently configured for internal clocking.
The clock speed is valid only for the slots that are set for internal clocking.
Valid clock speeds are as follows: 1200 (1200b), 2401 (2400b), 4807 (4800b),
7204 (7200b), 9615 (9600b), 19230 (19200b), 32051 (32000b), 38461
(38400b), 56818 (56k), 64102 (64k), 125000 (125k), 227272 (230k), 416666
(420k), 625000 (625k), 833333 (833k), 1250000 (1mb), 2500000 (2mb), and
5000000 (5mb).
Note: All internally clocked ports on a slot change to the last configured
internal clock speed when you boot, save a dynamic configuration change, or
enter the
config command.
Vista de pagina 103
1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 265 266

Comentarios a estos manuales

Sin comentarios