Avaya Troubleshooting Routers Guía para resolver problemas Pagina 171

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 266
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 170
Reading the Event Log
117379-A Rev. A A-17
Dial-on-Demand Raise DTR Log
The following log shows a successful dial-on-demand connection between the
COM2 port in slot 2 and a modem configured for Raise DTR.
These messages appear only when you click on the port configured for
dial-on-demand, and set the Debug option under the Modem definition to
Enabled. If you are using the Technician Interface, set attribute #29 (the debug
attribute) of the object wfModemIfEntry to 1 (1 = enabled, 2 = disabled). The
Debug option is available with router software Version 8.01 and later.
The following message indicates that the Sync software module enabled the
COM2 port:
# 33: mm/dd/yy 14:14:02.826 INFO SLOT 2 SYNC Code: 9
Connector COM2 enabled.
The port completes initialization.
# 34: mm/dd/yy 14:14:03.095 DEBUG SLOT 2 SYNC Code: 16
Connector COM2 initialization complete
Environment address - 3051f040 Line record address - 3052d8bc
Hardware map address - 30514f9c Initialization block -
80007800
Receive descriptor ring - 80005000 Transmit descriptor ring -
80005800
# 35: mm/dd/yy 14:14:03.095 DEBUG SLOT 2 PCAP Code: 67
interface became local - line 202102
intf gate spawned - line 202102
# 36: mm/dd/yy 14:14:03.103 DEBUG SLOT 2 PCAP Code: 65
wait_state - line 202102
The FSM messages indicate that the modem and the router are communicating.
The first FSM message shows the state the router was in when the FSM Event that
follows occurred.
# 37: mm/dd/yy 14:14:04.100 DEBUG SLOT 2 SWSERV Code: 46
Connector COM2: FSM State: RDTR_DISCONNECTED(0)
Connector COM2: FSM Event: RDTR_EVENT_CCT_UP(1); isdn flags: 0x0
The following messages indicate that you configured the port for Raise DTR,
rather than V.25bis, and remind you to check the modem connection:
# 38: mm/dd/yy 14:14:04.100 INFO SLOT 2 MODEMIF Code: 22
Connector COM2: enable requested on cct 65535
Connector COM2: Starting, raise dtr mode, is modem connected and turned
on?
Vista de pagina 170
1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 265 266

Comentarios a estos manuales

Sin comentarios