Avaya Troubleshooting Routers Guía para resolver problemas Pagina 116

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 266
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 115
Troubleshooting Routers
6-8 117379-A Rev. A
Refer to one of the following sections if it pertains to your problem:
T
roubleshooting Telnet, FTP, and TFTP
Ping Does Not
Work
T
roubleshooting RIP
T
roubleshooting OSPF
Troubleshooting Telnet, FTP, and TFTP
The message Unknown Network or Network Unreachable indicates that the device
does not have a path to the requested network.
If the sender and the target are on the same LAN, verify that the network IP
address and subnet mask are the same for both interfaces.
If this message appears on a UNIX workstation, issue the
netstat -r command at
the workstation. The command displays the contents of the routing table and any
default routes. Check the port’s subnet mask, which determines whether networks
are local or remote. If the workstation is in routed mode, check the Telnet, FTP, or
TFTP daemon configuration.
Troubleshoot a Telnet, FTP, or TFTP connection as follows:
1. Use the Events Manager or the Technician Interface to filter the log to
display messages of all severity levels for the application.
The Technician Interface command is as follows:
log -fftwid -e
<TELNET | FTP | TFTP>
Example
If you are filtering events from Telnet, enter the following command:
log -fftwid -eTELNET
2.
Enter the following command to check the base records:
get <wfTelnet | wfFtp | wfTftp>.*.0
Example
get wfTelnet.*.0
The Delete attribute appears only in the Telnet and FTP base records. It shows
whether the protocol is created (1) or deleted (2).
Vista de pagina 115
1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 265 266

Comentarios a estos manuales

Sin comentarios