
Configuring PPP Services
3-30 117360-A Rev. A
Allowing PAP Rejection
Some peers do not use PAP. If you set the Allow PAP Reject parameter to Enable,
your router accepts the Reject message from such a peer and removes PAP from
the LCP configure-request. The default value is Disable.
Using the BCC
The BCC does not allow you to configure this parameter.
Using Site Manager
To allow a remote peer to reject the use of PAP authentication for this interface, do
the tasks in the following table.
Customizing CHAP
The Challenge Handshake Authentication Protocol imposes network security by
requiring that the peers share a plain-text secret. You specify that secret, as well as
other CHAP parameters, by configuring the parameters described in the next
sections. If you have not enabled CHAP, ignore these parameters.
Site Manager Procedure
You do this System responds
1. From the Protocols menu, choose PPP. The Interfaces menu appears.
2. Choose Interfaces. The Interfaces window opens.
3. Choose Lines. The Lines window opens.
4. Set Allow PAP Reject. (See page A-25.)
5. If you have no other PPP line parameters
to configure, click on OK. Otherwise,
continue with the Lines configuration.
The Interfaces window opens.
Note: For dial services that use CHAP, you must configure the CHAP secret
and the CHAP local name through the Dial menu. See Configuring Dial
Services for details.
Comentarios a estos manuales