Avaya Configuring PPP Services Manual de usuario Pagina 105

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 140
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 104
PPP Parameters
117360-A Rev. A A-7
Parameter: CCP Enable
Path: Protocols > PPP > Interfaces
Default: If you enable data compression when you configure PPP on this interface, this
parameter is automatically set to Enable. Otherwise, the default is Disable.
Options: Enable
| Disable
Function: Enables or disables data compression.
This parameter does not enable or disable data compression for the interface.
However, disabling the Compression Control Protocol (CCP) stops data
compression over this interface.
Instructions: To stop compression over this interface, set this parameter to Disable.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.2.2.1.49
Parameter: IPV6 Enable
Path: Protocols > PPP > Interfaces
Default: If you enable Internet Protocol, version 6 (IPv6) support when you initially
configure PPP on this interface, then the IPv6 parameter is enabled by default
for PPP. Otherwise, the default is Disable.
Options: Enable
| Disable
Function: Enables or disables the network control protocol for IPv6.
This parameter does not enable or disable IPv6 routing services for the
interface. However, disabling the network control protocol for IPv6 stops IPv6
traffic from being routed over this interface.
Instructions: To stop IPv6 traffic from being routed over this interface, set this parameter to
Disable.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.2.2.1.69
Vista de pagina 104
1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 139 140

Comentarios a estos manuales

Sin comentarios